Skip to main content ↑ ↓
Topic: Fan Clutch Module (Read 940 times) previous topic - next topic
0 Members and 2 Guests are viewing this topic.

Fan Clutch Module

Can anyone tell me if there is a replacement part for the "Fan Clutch Module" DanFoss #11162963?

I'm sure there has to be a replacement part for this>

Help?

Jim Clarke
07 Magna Galileo #6762

Re: Fan Clutch Module

Reply #1 –
Hi Jim,

When needing the third replacement of the S-D controller on our '01 Intrigue, #11238, I went with a wax valve from Source Engineering. Part plus install was less money and it is much more reliable. My only regret, I didn't go to the wax valve on the first replacement. Temp might hit 200 when pulling a hill on a hot Arizona summer day, but usually is 182-185.

Don Krahling
Yuma, AZ

Presently in SW Colorado for the summer.

Re: Fan Clutch Module

Reply #2 –
I had my mechanic talk to them. My fan module is working, it just keeps sending a fault code. This shows on my dash as "Check Engine" light. The wax module does not shut off that light.
I can't believe there is nothing newer that would address both.

Re: Fan Clutch Module

Reply #3 –
Quote from: Concreteman –
I had my mechanic talk to them. My fan module is working, it just keeps sending a fault code. This shows on my dash as "Check Engine" light. The wax module does not shut off that light.
I can't believe there is nothing newer that would address both.

What is the code that is set with the Check Engine light.  I am not aware of a code set in the ECM from the Sauer Danfoss controller, especially if it is "working".  I also have the ECM controlled fan (3 wire connector on SD controller).  A conversation with someone who understands the engine ECM programming  (Cummins or Cat) may be needed.

BRian
2007 Country Coach Allure 37 Sunset Bay 400ISL

Re: Fan Clutch Module

Reply #4 –
Slightly off topic; my 1999 CC Intrigue fails to send a
request for the hydrolic fan to speed up when the temps go up. I can’t seem to locate the control module. Any ideas?

Re: Fan Clutch Module

Reply #5 –
Is it a sauer danfoss fan controller?  had same problem....the sensor was bad.  It was in coolant line and was wired to the controller.