Country Coach Owners Forum Country Coach Motorcoach Forum

2000 CC Allure fresh water tank level indicator

October 14, 2019, 01:43:30 pm

Yahoo Message Number: 118635

---

Hey-

Just curious if anyone has had this happen, and if so what fixed it?

My 2000 CC Allure 36' #30443 fresh water tank level on my panel suddenly shows only "E" when the fresh water button is pressed. The tank is full.

I have the panel that has the buttons, and the 5 indicator LEDs which change based on the current button pressed.

All other tank indicators are reading correctly when those buttons are pressed (grey/black/propane, etc).

I've checked the wire connections on the tank, cleaned and used NOALOX electrical corrosion inhibitor on them. It was working one day, then the next, nada.

I've also removed and reseated the connectors on the tank indicator electronics board behind the switches. All looks clean there.

Thanks,

Wes
2000 CC Allure 36' #30443
Currently at Parker Canyon Lake, AZ

Quote Selected

Re: 2000 CC Allure fresh water tank level indicator

Reply #1 – October 17, 2019, 03:59:03 pm

Yahoo Message Number: 118652

---

I (thankfully) have not had this problem. You may want to check resistance on the tank senders. I'm not exactly sure what kind of sender your tank has (internal or external) but basically, if you've checked everything, its probably the sender. Having worked with other tank senders (fuel, water, etc) a bad sender usually sends "Zero" showing a broken connections somewhere, or "Full" showing a crossed or grounded wire somewhere. Someone with a 2000 vintage coach might know more. My Dad had a 2000 Magna, but I (thankfully) never had to work on it. Best, Jim

Jim and Jona Seifert

2007 Country Coach Intrigue Ovation 530 42'
Coach #12150
525 Cat C13 Allison 6spd
Toads: 2014 Ford F150 / 2007 Toyota FJ Cruiser w/ REMCO DS Disconnect.
Airforce 1 Brake system
Blue Ox Aventa II Towbar

Quote Selected

Re: 2000 CC Allure fresh water tank level indicator

Reply #2 – October 28, 2019, 11:41:19 am

In case anyone was interested in this-

Turns out after filling my tank 3-4 times with 100% reverse osmosis
water, the water no longer conducts electricity. I tested at the tap,
and it was down to 11 ppm.

Once I filled up with regular city water again, my tank level indicators
started working again.

Wes

Quote Selected